Hey everyone! As some of you may know, I love cats! I saw one of my friends with some of these cat ears so I decided to make my own! Let’s get started 🙂

Supplies Needed:
♥ Headband
♥ Pearls
♥ Copper wire
♥ Wire cutters (and round nose pliers)

♥ E6000 glue

♥ Toothpicks

Screen shot 2014-01-30 at 6.59.18 PMStep 1: Cut an 8-inch piece of copper wire

Screen shot 2014-01-30 at 7.05.59 PMStep 2: Get your round nose pliers and bend the center of the wire

Screen shot 2014-01-30 at 7.08.38 PMStep 3: Create 2 of these and since they are cat ears, you can round the top off a tad

Screen shot 2014-01-30 at 7.10.13 PMStep 4: Place and bend the two ears onto the headband so you can check where you want to place them. Bend the bottoms of the wires so you can place them on the headband

Screen shot 2014-01-30 at 7.10.59 PMStep 5: Cut about an inch off the ears with the wire cutters so we can glue it onto the headband

Screen shot 2014-01-30 at 7.12.49 PMStep 6: Get a toothpick and apply some E6000 onto the headband where the ears will sit

Screen shot 2014-01-30 at 7.14.08 PMStep 7: Place circles of E6000 glue onto the ears where you will place the pears. Place one at the point of the ear and 4 down along either side. Then place then pearls on top (you might have to hold them for a bit). Let them dry for 24-72 hours

Screen shot 2014-01-30 at 7.17.14 PMAnd we’re finished! Here’s the final result 🙂

Screen shot 2014-01-30 at 7.19.15 PMThanks for watching! Here’s the full video tutorial as well if you prefer that! :)

Comments (3)

Leave a Reply

Your email address will not be published. Required fields are marked *